| Item Name | |
| Part Number/Trade Name | DMD 675 PHTHALO BLUE MEDIUM PAINT |
| National Stock Number | 8010PDMD675 |
| CAGE Code | 47695 |
| Part Number Indicator | A |
| MSDS Number | 193485 |
| HAZ Code | B |
| Manufacturer Name | PPG |
| P.O. Box | 9 |
| Street | 4325 ROSANNA DR |
| City | ALLISON PARK |
| State | PA |
| Country | US |
| Zip Code | 15101 |
| Emergency Phone | 304-843-1300 |
| Information Phone | 440-572-2800 |
| Date MSDS Prepared/Revised | 23MAR98 |
| Active Indicator | Y |
| Appearance/Odor | VISCOUS LIQUID W/ AN ODOR CHARACTERISTIC OF THE SOLVENTS LISTED IN INGREDIENTS |
| Boiling Point | 212-410 F |
| Vapor Pressure | 6.3 |
| Vapor Density | >AIR |
| Specific Gravity | 0.949 |
| Evaporation Rate | 80 |
| Solubility in Water | 2.4 |
| Percent Volatiles by Volume | 79.090 |
| Chemical pH | NA |
| Container Type | R |
| Container Pressure Code | 1 |
| Temperature Code | 4 |
| Product State Code | L |
| Flash Point | 75 |
| Flash Point Method | PMCC |
| Lower Explosion Limit | 1.6 |
| Upper Explosion Limit | NA |
| Extinguishing Media | USE NFPA CLASS B EXTINGUISHERS DESIGNED TO EXTINGUISH NFPA CLASS IC FLAMMABLE LIQUID FIRES |
| Special Fire Fighting Procedures | WATER SPRAY MAY BE INEFFECTIVE. WATER SPRAY MAY BE USED TO COOL CLOSED CONTAINERS TO PREVENT PRESSURE BUILD-UP & POSSIBLE AUTOIGNITION OR EXPLOSION WHEN EXPOSED TO EXTREME HEAT. IF WATER IS USED, FOG NOZZLES ARE PREFERABLE. FIRE-FIGHTERS SHOULD WEAR SCBA & FULL PROT. CLOTHING |
| Unusual Fire/Explosion Hazards | KEEP PRODUCT AWAY FROM HEAT, SPARKS, FLAME, ETC. KEEP CONTAINERS TIGHTLY CLOSED WHEN NOT IN USE. DO NOT APPLY TO HOT SURFACES |
| Stability | YES |
| Stability Conditions to Avoid | WILL NOT UNDERGO HAZARDOUS REACTIONS |
| Materials to Avoid | STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG OXIDIZING AGENTS |
| Hazardous Decomposition Products | CARBON MONOXIDE, CARBON DIOXIDE, CHLORINATED PRODUCTS; OXIDES OF COPPER & NITROGEN; HYDROGEN CYANIDE; LOWER MOL POLYMER |
| Polymerization Conditions to Avoid | NOT SPECIFIED |
| Route of Entry: Skin | U |
| Route of Entry: Ingestion | U |
| Route of Entry: Inhalation | U |
| Health Hazards - Acute and Chronic | {INGEST} HARMFUL IF SWALLOWED {EYE} CAUSES SEVERE IRRITATION {SKIN} MAY CAUSE MODERATE IRRITATION. {INHALE} MAY BE HARMFUL |
| Symptoms of Overexposure | EYE WATERING, HEADACHE, NAUSEA, DIZZINESS, & LOSS OF COORDINATION |
| Emergency/First Aid Procedures | {INGEST} DO NOT INDUCE VOMITING. GENTLY WIPE OUT INSIDE OF MOUTH TO REMOVE ANY RESIDUAL MATERIAL {EYE} REMOVE CONTACT LENSES & FLUSH EYES IMMED. W/ GENTLE STREAM OF LUKE WARM WATER FOR AT LEAST 15 MIN. {SKIN} FLUSH IMMED. W/ WATER FOR AT LEAST 15 MIN FOLLOWED BY WASHING W/ SOAP & WATER. {INHALE} REMOVE TO FRESH AIR. APPLY OTHER SUPPORT MEASURES IF NECESSARY |
| Steps if Material Released/Spilled | PROVIDE MAXIMUM VENTILATION. ONLY PERSONNEL EQUIPPED W/ PROPER RESPIRATORY, SKIN, & EYE PROTECT. SHOULD BE PERMITTED IN THE AREA. REMOVE ALL SOURCES OF IGNITION. TAKE UP SPILLED MATERIAL W/ SAND, VERMICULITE, OR OTHER NONCOMBUSTIBLE ABSORB. MATERIAL |
| Waste Disposal Method | IN ACCORDANCE W/ LOCAL, STATE AND FED REGS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF THROUGH APPR. WASTE MGMT FACILITY |
| Handling and Storage Precautions | DO NOT STORE ABOVE 120 F. STORE LARGE QUANTITIES IN BUILDINGS DESIGNED & PROTECTED FOR STORAGE |
| Other Precautions | VAPORS MAY COLLECT IN LOW AREAS. IF THIS MATERIAL IS PART OF A MULTIPLE COMPONENT SYSTEM, READ THE MSDS FOR THE OTHER COMPONENTS BEFORE BLENDING |
| Respiratory Protection | NIOSH APPROVED PURIFYING RESPIRATOR W/ APPR. CARTRIGES OR POSITIVE PRESSURE, AIR SUPPLIED RESPIRATOR MAY REDUCE EXPOSURE |
| Ventilation | PROVIDE GENERAL DILUTION OR LOCAL EXHAUST |
| Protective Gloves | BUTYL RUBBER |
| Eye Protection | WEAR CHEMICAL SPLASH GOGGLES OR FULL FACE SHIELD |
| Other Protective Equipment | WEAR PROTECT. CLOTHING TO PREVENT CONTACT. APRON SHOULD BE CONSTRUCTED OF BUTYL RUBBER |
| Work Hygenic Practices | CLEAN CONTAMINATED CLOTHING & SHOES |
| Protect Eye | NO |
| Protect Skin | NO |
| Protect Respiratory | NO |
| Chronic Indicator | UNKNOWN |
| Contact Code | UNKNOWN |
| Fire Code | UNKNOWN |
| Health Code | UNKNOWN |
| React Code | UNKNOWN |
| Volatile Organic Compounds (P/G) | 5.79 |
| Volatile Organic Compounds (G/L) | 693.8669 |
| Ingredient # | 01 |
| Ingredient Name | BENZENE, ETHYL- |
| CAS Number | 100414 |
| Percent | 5 |
| OSHA PEL | 100 PPM |
| ACGIH TLV | 100 PPM |
| Ingredient # | 02 |
| Ingredient Name | 2-PROPANOL, 1-METHOXY-, ACETATE |
| CAS Number | 108656 |
| Percent | 10 |
| OSHA PEL | NE |
| ACGIH TLV | NE |
| Ingredient # | 03 |
| Ingredient Name | ACETIC ACID, BUTYL ESTER |
| CAS Number | 123864 |
| Percent | 50 |
| OSHA PEL | 150 PPM |
| ACGIH TLV | 150 PPM |
| Ingredient # | 04 |
| Ingredient Name | BENZENE, DIMETHYL- |
| CAS Number | 1330207 |
| Percent | 20 |
| OSHA PEL | 100 PPM |
| ACGIH TLV | 100 PPM |
| Ingredient # | 05 |
| Ingredient Name | 1-BUTANOL |
| CAS Number | 71363 |
| Percent | 10 |
| OSHA PEL | 50 PPM |
| ACGIH TLV | 50 PPM |
| Ingredient # | 06 |
| Ingredient Name | *BLOCK POLYMER-PIGMENT AFFINED GROUPS |
| CAS Number | 1003 |
| Percent | 5 |
| OSHA PEL | NE |
| ACGIH TLV | NE |